Electronics Engineering Blogs
Stay up to date about electronics engineering.
The 8255 microprocessor is also known as Programmable Peripheral Interface. It has 24 I/O pins. The three 8 bit ports are PA, PB, PC.
The Non-Conventional Energy Sources are those which are available for us at any time and are free of cost.
The Conventional Energy Sources are helpful in producing electrical power generation from Hydro, Thermal, Nuclear and Diesel power stations.
The precision rectifier has the capability of rectifying voltages which are of smaller magnitude than the forward voltage drop.
The circuit which produces the samples of the input voltage and holds those values for a definite amount of time is sample and hold circuit.
An interrupt is a condition that arises during the working of a microprocessor. The interrupts of 8086 initiate interrupt service through ISR
The DC Motor is an electrical machine which converts mechanical energy into electrical energy. It works on the principle of induced emf.
The DC Motor is an electrical machine which can be classified as Separately excited DC Motor, Permanent Magnet and Self excited DC Motor.
The state variables can be explained as a minimal set of states of a system which helps to determine behavior of the system.
The Conventional Energy Sources are helpful in producing electrical power generation from Hydro, Thermal, Nuclear and Diesel power stations.
Whenever a signal is sampled below Nyquist rate (fs < 2B), the signal is called under sampled and the Aliasing effect hampers the results.
Crystal Oscillator is specially designed in a circuit to provide low impedance when it operates in series-resonant mode and high impedance.
Are you curious and willing to know what you will learn from your electrical engineering degree? You have definitely come to the right place.
It is a resistor whose resistance changes with change in temperature.
Encoders convert 2N lines of input into a code of N bits and Decoders decode those N bits into 2N lines.
Logic Gates are device with two or more inputs and only one output. There are different types of gates used to obtain different logical expressions.
The clipper circuits are basically used to clip the portion of any input signal without changing the remaining part of the input waveform.